OK, got my new bullet feeder (tube type) and powder check die for my LNL progressive.
Got the feeder set up and working, setup the powder check die.
I prime off press so I setup the press as follows
Station 1, Powder measure w/PTX
Station 2. Hornady expander, (PTX does not work well with the bullets I am using)
Station 3. Powder check die
Station 4. Bullet feeder
Station 5. Seat + crimp
After running this way for about 200 rounds I discovered this was a less than ideal setup.
I will tell everybody what is wrong here in a bit, but want to see who is the quickest to point out the error of my ways.
Got the feeder set up and working, setup the powder check die.
I prime off press so I setup the press as follows
Station 1, Powder measure w/PTX
Station 2. Hornady expander, (PTX does not work well with the bullets I am using)
Station 3. Powder check die
Station 4. Bullet feeder
Station 5. Seat + crimp
After running this way for about 200 rounds I discovered this was a less than ideal setup.
I will tell everybody what is wrong here in a bit, but want to see who is the quickest to point out the error of my ways.