Going to build a loading room. l will be using my utility room. lts 19x7' with a door in the middle. Concrete floor. No windows. lts semi/finished inside. Plywood on the walls. Sheetrock on the ceiling. l am going to panel the walls and ceiling w/cedar tongue n groove. Heat/Cool will be from a 110 heat pump wall mounted. For security l will install a metal door/frame unit. A sensor will be tied to the house central alarm unit. Will probably put in a motion sensor too. One unknown is what is inside the walls/ceiling. l found a bit of insulation in one small area. None in others. Only access to the ceiling is to cut a hole and see. l know the ceiling is worth checking and adding insulation. What about the walls?? lt would be a PAIN to pull all that plywood off. They are covered by maybe a hundred small pieces. Could l pump them full of foam? 0r maybe tack 1/2'' foam on before installing cedar ?
thanks
282
thanks
282