Made another gadget

[doubleh]

I had a scrap of 3/8" aluminum that needed turned into something and I have been planning to make a handle for a brush to scrub carbon from chambers in my 22 LR rifles and also to use scrubbing revolver cylinders so I turned that little piece of scrap into a handle that will accept 8-32 brushes. A light knurl and some end shaping and it's ready to use.



Sorry for the missed letter in the header. I should have payed more attention.

 

[RetiredUSNChief]

You know...that looks very marketable!

I'd buy one if I ran across it!

 

[hso]

Sorry for the missed letter in the header.

Missed letter? What missed letter?

 

[wiscoaster]

Nice piece of work!!

 

[klcmschlesinger]

I'm with RetiredUSNChief. That is exactly the kind of gadget I buy. Looks good.

 

[KevininPa]

Better slap a patent on that. I like it!

 

[whughett]

Yep. I’ll take one.

 

[doubleh]

OK, just out of curiosity how much would you pay for one?

 

[hso]

Good gadget!

 

[Reloadron]

RCBS marketed one:


It was a $5 part. They were used mostly with large and small primer pocket brushes. I have several laying around. However, they no longer make this little $5 gadget. They now make and market a new fancy version which does the same thing and now cost $20. The new flavor does include the large and small primer pocket brushes. This is the new version. What would I pay for a nice knurled aluminum version? While I don't need one I would say in the $8 to $10 range. That does not include postage or any shipping.

Nice job on what you made.

Ron