Ok, I have Security Six. Like the gun, but I've got a problem. It appears that three of the chambers are mis-bored.
Starting with a perfectly clean gun, insert six rounds:
Chamber 1: Fits reloads and factory rounds perfectly.
Chamber 2: as above.
Chamber 3: as above.
Chamber 4: Fits Factory perfectly, reloads on insertion just a touch "sticky" on insertion.
Chamber 5: Fits factory, but reloads on insertion are very sticky.
Chamber 6: Fits factory, but reloads on insertion are very sticky.
The same reloads that stick on isnertion in my Security Six do NOT stick in my GP100. And mind you, the Security Six only sticks in three of the cylinders.
So, three chambers are tight. BUT, and here's the dilemna - factory loads fit just fine. It reloads that show the tightness.
Suggestions? I can assure you it's not a cylinder cleaning question!
Starting with a perfectly clean gun, insert six rounds:
Chamber 1: Fits reloads and factory rounds perfectly.
Chamber 2: as above.
Chamber 3: as above.
Chamber 4: Fits Factory perfectly, reloads on insertion just a touch "sticky" on insertion.
Chamber 5: Fits factory, but reloads on insertion are very sticky.
Chamber 6: Fits factory, but reloads on insertion are very sticky.
The same reloads that stick on isnertion in my Security Six do NOT stick in my GP100. And mind you, the Security Six only sticks in three of the cylinders.
So, three chambers are tight. BUT, and here's the dilemna - factory loads fit just fine. It reloads that show the tightness.
Suggestions? I can assure you it's not a cylinder cleaning question!