So I have this 50-90 sharps I load black powder for. When the brass was new I full length sized all of it then I was told for bolt/single shot guns if the brass was only going to be used in that gun you do not need to full length size. ok great. Then I was told because it was black powder I dont even need to neck size if the loaded round chambers.
So how do I neck size only with a full length sizeing die?(if my cases nolonger feed)
Also my dies deprime on the full length sizer, so how do I deprime now.
This brass is expensive so I would really like to get some long case life out of them.
So how do I neck size only with a full length sizeing die?(if my cases nolonger feed)
Also my dies deprime on the full length sizer, so how do I deprime now.
This brass is expensive so I would really like to get some long case life out of them.