ALP1
Member
Over the past few years I've been assembling the equipment but never really got started till just the past few mths. I've got an RCBS Turret press, I was depriming and resizing 45 acp. After about 900 cases, the action had gotten so stiff it was almost impossible to complete a stroke without two hands. I tried putting a little grease on the ram, that helped a little for a couple strokes, then I tried cleaning all the grease off the ram, that helped for a couple more strokes. So what is likely causing the restriction on the ram? What is the proper oiling/lubing and maintenance procedure?