How does one go about depriming unfired brass safely? I'd like to resize and trim them for use in an X-die to minimize trimming in the future - I HATE TRIMMING!
Which leads me to... what's the most expeditious way to trim, debur, and champfer? I'm looking at reloading about 1000 rounds a week or so. Does the RCBS Trim Pro and 3-way cutter really work? I've tried the Lee case trimmer and it sucked. The rod that goes down into the case get's hung up on something down in there - I assume that it's something related to the primer pocket. I had to actually chuck it up and grind the shoudler back and add a steeper taper to get it to the point where the pin would pass through enough to actually bottom out on the holder.
Thanks!
Which leads me to... what's the most expeditious way to trim, debur, and champfer? I'm looking at reloading about 1000 rounds a week or so. Does the RCBS Trim Pro and 3-way cutter really work? I've tried the Lee case trimmer and it sucked. The rod that goes down into the case get's hung up on something down in there - I assume that it's something related to the primer pocket. I had to actually chuck it up and grind the shoudler back and add a steeper taper to get it to the point where the pin would pass through enough to actually bottom out on the holder.
Thanks!