I have a 1924 Nitro Special 12 ga. The gun had not been used for 20+ yrs. After about 100 to 150 rounds the gun began to hang up when trying to break it open after firing. I have cleaned the action well and lubed it. The firing pins appear to move freely. After firing, they extend 0.087” and 0.073” from the breach face. There is 0.010” and 0.016” clearance under the cocking cams
I have not taken any of the receiver apart at this time. Should I look at replacing the cocking cams or cocking rods? Can I replace the cocking rods by pulling out the front when the cams are removed?
I have not taken any of the receiver apart at this time. Should I look at replacing the cocking cams or cocking rods? Can I replace the cocking rods by pulling out the front when the cams are removed?