RavenVT100
Member
- Joined
- Aug 18, 2004
- Messages
- 1,107
Specifically, the Gas Cylinder Lock Screw Valve, i.e. that little plug that screws into the front below the barrel to lock the Cylinder Lock against the Cylinder. As I was cleaning my Garand tonight after firing approx. 100 rds of .30-06, I noticed that this part was loose.
Did I just not tighten it enough the last time I did a full strip? This has never happened before. Could anything have gotten damaged? It screwed back into place fine and I tightened it very hard this time.
How can I ensure that it stays put without hurting anything?
Did I just not tighten it enough the last time I did a full strip? This has never happened before. Could anything have gotten damaged? It screwed back into place fine and I tightened it very hard this time.
How can I ensure that it stays put without hurting anything?