azrocks
Member
- Joined
- Jun 28, 2016
- Messages
- 659
Before I didn't know you weren't supposed to just leave the powder in the hopper...
I've got one Dillon powder drop where the transparent plastic cylinder is stained / etched from powder. Doesn't matter functionally but I'm tired of looking at it. Is there a way to bring it back to looking close to clean? May end up selling this stuff in the near future so it would also make sense to pretty it up for that reason.
I've got one Dillon powder drop where the transparent plastic cylinder is stained / etched from powder. Doesn't matter functionally but I'm tired of looking at it. Is there a way to bring it back to looking close to clean? May end up selling this stuff in the near future so it would also make sense to pretty it up for that reason.