One of the great values of QL is finding candidate load combinations that fit parameters you specify: pressure, speed, fill-ratio, total burn % (etc). From there you pick options to try as "probable" best.
Ran into an issue yesterday where I wanted a 1,100 fps/light-recoil LEGEND and so set that speed into the Propellant Table setup and hit "go"
Got a lot of these:
"...cannot find match... try to lower shot start pressure..."
Now I can lower shot start to "zero" and the same error appears in the table.
Any thoughts?
postscript: I can put any of these powders into the regular load entry screen, and get perfectly acceptable results. But not in a Propellant Table search.
'Tis a puzzlement.
Ran into an issue yesterday where I wanted a 1,100 fps/light-recoil LEGEND and so set that speed into the Propellant Table setup and hit "go"
Got a lot of these:
"...cannot find match... try to lower shot start pressure..."
Now I can lower shot start to "zero" and the same error appears in the table.
Any thoughts?
postscript: I can put any of these powders into the regular load entry screen, and get perfectly acceptable results. But not in a Propellant Table search.
'Tis a puzzlement.
