Loading on a LNL AP, I switched to a new RCBS sizing die as I found it would size a little tighter than my Hornady die. Now, very often a case will catch on the edge of the die near the primer tube, and will either hang things up, or cause me to crunch the case. When it hangs, I can push the case inward slightly, and it goes right into the die.
I've tried a new shell plate spring, new Hornady die spacer, ran a case up then tightened the die nut, ensured the shell plate bolt is tight. Not sure what else to try.
I'll try calling RCBS tomorrow. Any other ideas?
I've tried a new shell plate spring, new Hornady die spacer, ran a case up then tightened the die nut, ensured the shell plate bolt is tight. Not sure what else to try.
I'll try calling RCBS tomorrow. Any other ideas?