Amish_Bill
Member
I've got a 700p that I want threaded for a suppressor. Normally I'd just have a smith cut it down a few inches (currently 26) and re-crown & thread.
The issue - I've read some less than glowing comments on the quality of rem factory barrels, even on the P models. This is compounded by a chunk of rifling that is missing an inch or two back from the muzzle. I don't know if there are more, as I don't have a borescope. (strangely, it shoots fed GMM Very Very well)
Dillema - do I same some cash and have the bad portion cut off the muzzle, taking the risk there is more damage hiding in the bore, or do I have a fresh high quality barrel threaded and put on?
Any ideas what the price difference might be between these options? The odds there are more flaws in my existing barrel?
The issue - I've read some less than glowing comments on the quality of rem factory barrels, even on the P models. This is compounded by a chunk of rifling that is missing an inch or two back from the muzzle. I don't know if there are more, as I don't have a borescope. (strangely, it shoots fed GMM Very Very well)
Dillema - do I same some cash and have the bad portion cut off the muzzle, taking the risk there is more damage hiding in the bore, or do I have a fresh high quality barrel threaded and put on?
Any ideas what the price difference might be between these options? The odds there are more flaws in my existing barrel?