In my way of thinking the shaft should not be installed that tight. The shaft should be just tight enough to de-prime, but still allow the shaft to get pushed out of the way should a Berdan primer show up. But to each his own.
I do not deprime until after sizing and polishing so on my lee dies I use a set of small vise grips to remove the decapping pin on all my Lee bottle necked dies. This works well for what I do. YMMV
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.