tomrkba
Member
- Joined
- May 30, 2010
- Messages
- 2,370
I have two GP100s. My stainless gun is older and my GP-141 (black) is very new, with approximately 300 rounds through it. I took both guns apart to clean them. I reassembled both and the hammer on the GP-141 only moves 1/4" back when I pull the double action trigger. I can fully cock it manually. The stainless gun works fine.
I disassembled both guns multiple times. I compared each gun during each step of the process. The trigger group on the GP-141 seems to be functioning identically to the stainless gun's trigger group. The hammer block and hammer spring struts appear to be in the correct location.
What would cause the hammer to stop moving when the trigger is pulled? What do I need to check internally? How do I fix it?
I disassembled both guns multiple times. I compared each gun during each step of the process. The trigger group on the GP-141 seems to be functioning identically to the stainless gun's trigger group. The hammer block and hammer spring struts appear to be in the correct location.
What would cause the hammer to stop moving when the trigger is pulled? What do I need to check internally? How do I fix it?