Sylvan-Forge
Member
Picked up the foundation yesterday. A S&W model 10-14, new manufacture.:
Everything looked ok, so I fired 50 rounds of Magtech 148 wadcutter to get a feel for it. The action was stiff, which is to be expected, but I imagine it would still be too heavy for my tastes even after it's worn in.
Here's what's in store:
S&W PC Master Revolver Action Package:
Ordered the Express Service
-Trigger Stop (going to subtract this)
-Chamfer Charge Holes
-Polish Rebound Spring, Hammer Stud and Yoke Barrel Bosses
-Detail Lockwork Surfaces
-Stone Hammer and Trigger Contact Areas
-Test Fire for Function
3.5 bull barrel, non-stainless (Manufacturer? Revolversmith?)
Might be cool to integrate a little laser(s) into the barrel .. hmmm ..
-Recessed crown
-Slab sided
-Integral ejector rod shroud
-Dehorned
Cylinder & Slide sight installation
-C&S Extreme Duty fixed rear sight
-Dovetailed front sight, serrated (Manufacturer?)
Tooltech Gunsight
Sight mods
-Green tritium, white ring front
-Single yellow tritium dot, black ring rear
I've a set of S&W service grips on the way from MidwayUSA and a black Tyler T-grip coming from Tyler manufacturing to get things started, though I may add additional grips later.
Yet to decide on the finish, though it will probably be something weird or tackycool. It is to be a 'combat' revolver of course
I'll post pics and info as they happen, so if you want to follow along for the ride, stay tuned!
.
Everything looked ok, so I fired 50 rounds of Magtech 148 wadcutter to get a feel for it. The action was stiff, which is to be expected, but I imagine it would still be too heavy for my tastes even after it's worn in.
Here's what's in store:
S&W PC Master Revolver Action Package:
Ordered the Express Service
-Trigger Stop (going to subtract this)
-Chamfer Charge Holes
-Polish Rebound Spring, Hammer Stud and Yoke Barrel Bosses
-Detail Lockwork Surfaces
-Stone Hammer and Trigger Contact Areas
-Test Fire for Function
3.5 bull barrel, non-stainless (Manufacturer? Revolversmith?)
Might be cool to integrate a little laser(s) into the barrel .. hmmm ..
-Recessed crown
-Slab sided
-Integral ejector rod shroud
-Dehorned
Cylinder & Slide sight installation
-C&S Extreme Duty fixed rear sight
-Dovetailed front sight, serrated (Manufacturer?)
Tooltech Gunsight
Sight mods
-Green tritium, white ring front
-Single yellow tritium dot, black ring rear
I've a set of S&W service grips on the way from MidwayUSA and a black Tyler T-grip coming from Tyler manufacturing to get things started, though I may add additional grips later.
Yet to decide on the finish, though it will probably be something weird or tackycool. It is to be a 'combat' revolver of course
I'll post pics and info as they happen, so if you want to follow along for the ride, stay tuned!
.