Deadmanwalking_05
Member
- Joined
- Aug 11, 2008
- Messages
- 101
I'm set to put the first down payment on an S&W 617.
I'm going for the 4-inch 10 shot.
And am going to dress it up with checkered service grips and an engraving (Going to do the same engraving for the Model 67 which is next on my purchase list)
The only section I'm going to have engraved is the right side plate.
I'm trying find a skull pic that would work ,and a few lines of text that would read "Death's Right Hand" underneath the skull.
Would it be cheaper just to buy the right side plates (Model617 and 67) without the factory stamp,and send those off instead of sending my revolvers in along with them?
How much do you guys think it would cost to dress up the two revolvers?
I'm going for the 4-inch 10 shot.
And am going to dress it up with checkered service grips and an engraving (Going to do the same engraving for the Model 67 which is next on my purchase list)
The only section I'm going to have engraved is the right side plate.
I'm trying find a skull pic that would work ,and a few lines of text that would read "Death's Right Hand" underneath the skull.
Would it be cheaper just to buy the right side plates (Model617 and 67) without the factory stamp,and send those off instead of sending my revolvers in along with them?
How much do you guys think it would cost to dress up the two revolvers?