• You are using the old High Contrast theme. We have installed a new dark theme for you, called UI.X. This will work better with the new upgrade of our software. You can select it at the bottom of any page.

Smith and Wesson 2206

Status
Not open for further replies.

Drakejake

Member
Joined
Dec 31, 2002
Messages
826
Location
Nashville, TN
I own two of these pistols. Each is stainless and has a six inch barrel. I shot both in the past few days. I shoot cheap value pack ammo from Wal-Mart. I have been shooting Federal hollow point from 550 round boxes. I am just a plinker so I am not picky about ammo if it works. The last two times I was shooting with a suppressor and had some jams. I don't know whether they were caused by the can or by my failure to clean the pistol. I think the 2206 with six inch barrel is a great value. I tried shooting them with an optical scope but this didn't work for me. I removed the scopes and shoot with the iron sights. These are accurate pistols with very good triggers.

I had an extra large padded gun case for the 2206. I added a strap and found that the case worked very well as a shoulder holster for the pistol with suppressor attached.

Drakejake
 

Attachments

  • IM002137.JPG
    IM002137.JPG
    362.5 KB · Views: 56
  • IM002138.JPG
    IM002138.JPG
    420.9 KB · Views: 15
  • IM002139.JPG
    IM002139.JPG
    468.2 KB · Views: 18
I've owned the 422 and 622. I always thought they were very reliable, accurate, and fun guns. Mine always would work with any brand of ammo I had on hand too.
 
This pistol works well with a suppressor. You can buy an adaptor on Gunbroker.com and use it to replace the barrel shroud. The suppressor screws right on, no barrel threading required. That is what I did.

Drakejake
 
Status
Not open for further replies.
Back
Top