HRnightmare
Member
- Joined
- Jul 30, 2014
- Messages
- 630
The other day I noticed my suppressor seems to be at an awkward angle on my pistol. I set it down on the table and it is very noticeable not on straight and instead angles towards the left.
I removed the thread nut that attaches the barrel to the suppressor and it is on properly, not cross threaded or stripped. I also took the suppressor apart and everything is good with that.
I did not notice this until firing about 10 rounds. No baffle strikes or stuck rounds so it is firing fin but is bothering me...AND I also noticed I cannot hit ANYTHING with the gun. I was shooting in my backyard and didn't have safe space to set up a target and adjust the rear sight but I suspect the suppressor being angled is part of the issue.
I am perplexed as to how it is not straight yet both the barrel and barrel adapter is on properly and not angled (from what I can tell) and how it is not causing baffle strikes.
Any ideas or suggestions?
I removed the thread nut that attaches the barrel to the suppressor and it is on properly, not cross threaded or stripped. I also took the suppressor apart and everything is good with that.
I did not notice this until firing about 10 rounds. No baffle strikes or stuck rounds so it is firing fin but is bothering me...AND I also noticed I cannot hit ANYTHING with the gun. I was shooting in my backyard and didn't have safe space to set up a target and adjust the rear sight but I suspect the suppressor being angled is part of the issue.
I am perplexed as to how it is not straight yet both the barrel and barrel adapter is on properly and not angled (from what I can tell) and how it is not causing baffle strikes.
Any ideas or suggestions?