Tango Down, non-quick detach Vertical Fore-Grip Removal.

[againstthagrane]

I made the mistake of cramming on my Tango Down grip onto my MI rail system even though it should have been fitted properly before installation. (I have to claim ignorance on this, because it was my first fore-grip and no one told me any differently, including the manual).

Does anyone have any tips on removal? Because, short of knocking it off with a hammer and screwing my upper up it's not budging. Any suggestions would be appreciated.

 

[2ac]

Hold the attachment buttons down with the zip tie heads. Or whatever else is handy and fits snug. Muzzle on the floor, now give a good firm push. You might have to tap it a bit. As long as those tabs are disengaged you shouldn't screw anything up. Mine is very snug too. That's a good thing.