daniel craig
Member
- Joined
- Dec 23, 2009
- Messages
- 2,815
So I’m putting together the barreled action in the magazine and trigger guard parts of my Mosin-Nagant. Basically at the top and the bottom well when I go to screw everything in with the front screw… When the screw is hand tight it actually warms the stock a little bit and pushes the top of the magazine up into where the bolt needs to go and I can’t close the bolt. Loosening that screw drops the magazine down and makes it so I can manipulate the bolt but there’s literally no purchase on that screw.
I think what’s happen here is that when I’m tightening the bolt the stock actually warps the a wood stock wouldn’t and that’s caused the pieces to misalign.
I THINK the solution is going to be a shim between the magazine and the stock itself or put the whole thing in wood.
I think what’s happen here is that when I’m tightening the bolt the stock actually warps the a wood stock wouldn’t and that’s caused the pieces to misalign.
I THINK the solution is going to be a shim between the magazine and the stock itself or put the whole thing in wood.