amd6547
Member
I went from the Hogue overmold forend to the Magpul forend on my Mossberg 500. In comparison to the Hogue, the polymer Magpul felt a little slippery to my taste.
I had previously used Tractiongrips rubber stick on grip on my keltec P32 with good result, so I ordered their stick on grip for the Magpul forend.
It was cut perfectly to fit the Forend. It comes in four pieces, a front piece and rear piece for each side. As directed, I cleaned the forend with soap and water first. Then it was time to peal the backing, and apply the grip. Application was easy, and it fit great. Finally, hit with a hair dryer to set it.
The result is great. Grip is much improved. I like to use a push/pull hold, where I maintain forward pressure on the forend, so a good grip is important to me. The Tractiongrips is a definate upgrade for me.
I had previously used Tractiongrips rubber stick on grip on my keltec P32 with good result, so I ordered their stick on grip for the Magpul forend.
It was cut perfectly to fit the Forend. It comes in four pieces, a front piece and rear piece for each side. As directed, I cleaned the forend with soap and water first. Then it was time to peal the backing, and apply the grip. Application was easy, and it fit great. Finally, hit with a hair dryer to set it.
The result is great. Grip is much improved. I like to use a push/pull hold, where I maintain forward pressure on the forend, so a good grip is important to me. The Tractiongrips is a definate upgrade for me.
