Howdy:
I have done some pistol reloading, but it is now time I reloaded rifle rounds.
I was wondering if y'all trimmed brass you obtained by purchasing factory ammo & firing through your own rifle?
Or, since my once fired brass is from different manufacturers, should I trim them all to the same length anyway, after depriming/sizing?
If I trim, ought I trim all to the min spec?
I plan to start with 6.5x55 in my 96/38 Swede Mauser.
My first instinct is to full lendth resize & trim all to min length, but I thought that some of y'all might have a tip or trick.
Thanks.
I have done some pistol reloading, but it is now time I reloaded rifle rounds.
I was wondering if y'all trimmed brass you obtained by purchasing factory ammo & firing through your own rifle?
Or, since my once fired brass is from different manufacturers, should I trim them all to the same length anyway, after depriming/sizing?
If I trim, ought I trim all to the min spec?
I plan to start with 6.5x55 in my 96/38 Swede Mauser.
My first instinct is to full lendth resize & trim all to min length, but I thought that some of y'all might have a tip or trick.
Thanks.