Ok, here's the situation. I have successfully loaded a few hundred 30 Carbine at this point, but I'm finding the trimming to be a royal pain in the backside. Looking for a better solution. Right now I'm using a Lee trimmer on my cordless drill, and thats fine, it works. However, the process is, take my deprimed, tumbled brass, size it, and then I have to flare it in order to get the length gauge to fit, trim, and measure. Also, its not the most repeatable process. I'd say I wind up with 5-10% that wind up being a hair short. Trim to length I'm shooting for is 1.286, and I'm within 2-3 thousands 90% of the time, but some get down to 1.280, or so.
So, I'm looking for a trimmer that does not require me to flare before trimming, and that is a little more precise than the Lee system. And hopefully can speed this process up a bit.
I've been loading for an early Plainfield, but we recently, and unexpectedly just had twins......a gen 1 Universal, and a Winchester. So now with 3 hungry mouths to feed, I need to up the efficiency
So, I'm looking for a trimmer that does not require me to flare before trimming, and that is a little more precise than the Lee system. And hopefully can speed this process up a bit.
I've been loading for an early Plainfield, but we recently, and unexpectedly just had twins......a gen 1 Universal, and a Winchester. So now with 3 hungry mouths to feed, I need to up the efficiency