- Joined
- Mar 12, 2009
- Messages
- 3
Howdy--
Hoping someone has some insight...
Had my Uberti Schofield in .45 out to the range, and had a good time with it. Except I noticed that the cylinder wouldn't spin easily...I put it down to being dirty, having been using Unique loads.
But when I got home, I found that the cylinder, with the frame closed, would spin very hard. Cocking the hammer was hard, and could sometimes work or not, almost like the timing was off.
Open the gun, the cylinder spins freely, the cocking mechinism works fine. It's just the cylinder feels tight in the frame...i cleaned it again, and it loosened up some, but still the hand doesn't always engage...
Brand new gun...
Any ideas?
Thanks
Leadbelcher
Hoping someone has some insight...
Had my Uberti Schofield in .45 out to the range, and had a good time with it. Except I noticed that the cylinder wouldn't spin easily...I put it down to being dirty, having been using Unique loads.
But when I got home, I found that the cylinder, with the frame closed, would spin very hard. Cocking the hammer was hard, and could sometimes work or not, almost like the timing was off.
Open the gun, the cylinder spins freely, the cocking mechinism works fine. It's just the cylinder feels tight in the frame...i cleaned it again, and it loosened up some, but still the hand doesn't always engage...
Brand new gun...
Any ideas?
Thanks
Leadbelcher