martinb3152
Member
- Joined
- Oct 14, 2015
- Messages
- 54
Hello, I have a dillon 550b that was passed on down from my brother and I have been reloading .45acp with it currently. But I ran across this case when cleaning my brass and I can't make what origin this case came from. It fits into my .45acp dies really tight. So I am not going to use them. It looks like it's made out of a combination of nickel and brass or something. I found quite a few of these at the range, so I guess it's kind of a common case. I am also am having some seating problems with some cases. I have to press down fairly hard to get them to seat properly. The press is clean, so I don't know what else it could be except that maybe I should get a primer pocket cleaning tool to clean the pockets before I load? Any suggestions or tips would be greatly appreciated....
thanks,
martinb3152
thanks,
martinb3152
Attachments
Last edited: