bigalexe
Member
This may belong in accessories.
I have a Mossberg 500 and recently fitted a Knoxx/Blackhawk Spec Ops stock to it. I went to dis-assemble the guns receiver for the purpose of cleaning and oiling which previously involved removing a single pin (to drop the trigger assembly) so the only tool needed was a strong fingernail or a stiff pen. However the Knoxx Stock fits tightly onto the trigger housing, so the STOCK MUST BE REMOVED if you want to dis-assemble the receiver unlike with a normal stock.
Just a point I thought i would post because i was very upset when i had everything setup to clean my gun and realized i then needed a 1/4" Allen Wrench.
I have a Mossberg 500 and recently fitted a Knoxx/Blackhawk Spec Ops stock to it. I went to dis-assemble the guns receiver for the purpose of cleaning and oiling which previously involved removing a single pin (to drop the trigger assembly) so the only tool needed was a strong fingernail or a stiff pen. However the Knoxx Stock fits tightly onto the trigger housing, so the STOCK MUST BE REMOVED if you want to dis-assemble the receiver unlike with a normal stock.
Just a point I thought i would post because i was very upset when i had everything setup to clean my gun and realized i then needed a 1/4" Allen Wrench.