Question for the experts--I have an 1860 Army by Pietta about a year old that has had only a couple hundred rounds fired through it. The wedge screw is screwed in all the way. The wedge goes in with very light finger pressure all the way to the screw. Any tapping I do on it to tighten it up only forces the screw over the stop on the wedge. I have only been able to get so-so accuracy with the revolver. Do you think I need to order a new wedge that might fit tighter thus reducing the cylinder gap and improving accuracy? When the wedge is in until the stop on it contacts the wedge screw it can be pushed back out with finger pressue only. Thanks for any advice anyone might give.