Looking for the fastest and easiest way to trim.
I have the RCBS Manual Trim Mate with the 3 way cutter that chamfers and de burrs at the same time (it's pretty slick) I have the powder drill adapter (just a hex shaft rod that you shove in instead of the turning knob. I have done a few hundred with the hand crank and that gets old real fast.!
So it's push on the handle, insert case, pick up drill shove it in trim, put down drill remove case put in the next. etc.
I looked at the Worlds Finest Trimmer which looks good, fast and easy but then you still need to de burr and chamfer so that is handling the same brass 2 or 3 times.Plus brass chips are flying all over (I can work that out)
What I like is no piolts, shell holders to unlock just shove the case in by hand.
http://www.midwayusa.com/product/997722?cm_vc=S014
Then I could use this gadget.
http://www.midwayusa.com/product/245424?cm_vc=S014
So would this set up beat what I have???
Any other ideas??
I have the RCBS Manual Trim Mate with the 3 way cutter that chamfers and de burrs at the same time (it's pretty slick) I have the powder drill adapter (just a hex shaft rod that you shove in instead of the turning knob. I have done a few hundred with the hand crank and that gets old real fast.!
So it's push on the handle, insert case, pick up drill shove it in trim, put down drill remove case put in the next. etc.
I looked at the Worlds Finest Trimmer which looks good, fast and easy but then you still need to de burr and chamfer so that is handling the same brass 2 or 3 times.Plus brass chips are flying all over (I can work that out)
What I like is no piolts, shell holders to unlock just shove the case in by hand.
http://www.midwayusa.com/product/997722?cm_vc=S014
Then I could use this gadget.
http://www.midwayusa.com/product/245424?cm_vc=S014
So would this set up beat what I have???
Any other ideas??