conan32120
Member
personally .380 is giving me fits, run them thru the sizing die then a touch of expander and some bullets crush the case others fall right in with no tension at all. any one else feel like proclaiming their pita cartridge?
What are you having issues with?5.7X28, hands down the most PIA round to load.
I loaded it successfully, it's just a PIA.What are you having issues with?
5.7X28, hands down the most PIA round to load.
I load it for both the Five-seveN pistol and PS90.so it’s reloadable? I have avoided it because I thought it wasn’t. It was only for pistols that I’d considered it. I hear the P90 is more of a PITA.
38 special for bullseye is rough. A key to bullseye accuracy is to make sure the bullet isn't swaged as it is seated. My expander plug expands the full length of the bullet, and this gets stuck!
I separated a case head last night. After fixing that, I polished the crap out of the plug with the fine paper I use to sharpen my chisels (went to 60000 grit, kinda overkill).
Then loaded about 250 with a Zero HBWC seated flush over 2.7gr of BE. That took forever since I used a cotton swab to make sure One Shot got on the inside of each case. Kind of kills the advantage of a progressive press.
My 158gr Round Nose group about 3in at 50y. I'm told that's doing pretty good for those bullets.
These are the first HBWC I've loaded, but I'm told they naturally shoot better, so I guess I'm looking for under 3in at 50y. Best I've ever seen was a smidge under 2 in at 50y.
17 Remington small bullets thin necks small hole to get powder in