WTK: Lee 10mm Bulge buster Die

[Dane R. Marley]

Is there a special Lee die for the 10mm bulge buster operation or is it just the Lee Carbide Crimp die that you pass the bulged cartridge through?

 

[CoalCrackerAl]

I have never used a bulge buster die. I have loaded a lot of ''Glocked'' brass with Lee's carbide die sets.

 

[Dane R. Marley]

I found the answer in a youtube video, it is the Carbide Crimp Die.

Lee Bulge Buster Kit For 40 SW

www.youtube.com

 

[Dane R. Marley]

I found an interesting video on this subject. https://www.bing.com/videos/rivervi...1BC71669C102CE7A6F421BC71669C102CE&ajaxhist=0

 

[vaalpens]

The .40s&w Lee FCD is used as bulge buster for .40s&w, 357sig and 10mm.

 

[Lennyjoe]

Get the Lee .40 cal bulge buster and don’t look back. I’ve used it in the past with good results. But lately the 10MM I have found didn’t require the bulge buster, just a standard sizing die.

 

[BBarn]

For the 10mm, you want the Lee Carbide Factory Crimp Die SKU# 90862 for use with the Bulge Buster Kit.

 

[BJung]

Warning: if you bust the bulge but the case is discolored, toss it. I overlooked this once and my brother's 10mm blue up in my hand.

 

[Soonerpesek]

Is there a special Lee die for the 10mm bulge buster operation or is it just the Lee Carbide Crimp die that you pass the bulged cartridge through?

This is the setup I purchased, it is my ONLY FCD….and used ONLY for this purpose…

 

[TEXASJD]

No issues with mine in 10mm

 

[chevrofreak]

Get the Lee .40 cal bulge buster and don’t look back. I’ve used it in the past with good results. But lately the 10MM I have found didn’t require the bulge buster, just a standard sizing die.

I've had the standard Lee sizing die remove an impressive amount of case bulge. I haven't needed anything else yet.