-
-
As I said to 38Special, if the lube is stiff enough to be rolled into pills, and pressed over the ball or bullet, it will stay in the... -
thanks hawg. I couldn't find where I had that info.
-
I know. I'm right handed but when I saw it I had to have it.🤣
-
hawg replied to the thread 45 cal. conversion cylinders ?.No. The Pietta cylinder is longer.
-
Looking good, Hawg.
-
hawg replied to the thread I found caps!.I don't know how accurate this is. I haven't measured anything myself.
-
-
hawg replied to the thread Good starting load..My .50 liked 90 grains.
-
Those look just like my "Zhears" They are pretty handy, whatever they are.
-
hawg replied to the thread Cutting Aluminum Cans.I don't know what zhears are but a pair of medical utility scissors don't cost much and will cut anything from paper to coins and 1/4...
-
-
hawg replied to the thread Good starting load..That's a nice rifle except somebody screwed up and put the lock on the wrong side. :p What Malachi said except I'm pretty sure that...
-
I would start at 80 grains of BP with whatever projectile you fancy and move up from there until maximum accuracy is achieved. If by...
-
hawg replied to the thread 45 cal. conversion cylinders ?.Yeah it's the same frame.
-
hawg replied to the thread Long hunter knife.Thanks. Maybe half the price of a cheap one but that's not counting the propane. The blade isn't all that thick but it's sturdy. I've...
-
hawg replied to the thread More reliable Remington or colt cast your vote n tell why.Might as well. It's the only way a capper will work.
-
hawg replied to the thread Long hunter knife.No. I used large cutoff wheels on a Dremel to cut it out while keeping it wet to keep the heat down. I'm not going to say how many...
-
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
