Search results for query: *

Hello, Recently purchased a Browning 1911-22 rimfire 1911 and after firing a few hunfred rounds decided to field strip and clean it. Upon reassembly I noticed that the fit between the barrel and the barrel bushing is much looser than other 1911 style guns that I have. Is this loose fit common...

Does anyone have any experience or knowledge about cylinder binding on new S&W model 63 revolvers when using high velocity ammo such as Federal champion 36 gn hp 1260 fps ammo? I sent mine back to S&W because of cylinder binding right out of the box and just got it back. They stated on the paper...

I'm considering a Smith & Wesson Model 10 for my next gun purchase. Would anyone who owns one care to share their opinion of it? Shooting is a fairly new interest of mine and I sometimes prefer to get input from those who are more experienced. Thanks to all.

I just purchased a new Smith & Wesson Mod 36 38 special revolver and have also purchased some American Eagle 38 spec 130 gn FMJ ammo for it. I selected this ammo because I've used the American Eagle brand 357 158 gn FMJ in my S & W 686 and it seems to be good ammo to shoot at the range because...

I recently purchased a S&W model 686 revolver. Last week I purchased some Winchester 110 gn 357 mag ammo and shot about 14 rounds. Later on while reading through the instruction manual that came with the 686, I noticed on page 12 it stated "caution: do not use magnum loadings with bullet weights...

Does anyone know why CCI Blazer ammo might be banned at some shooting ranges? I've read in some ammo reviews that it's not only the aluminum cased ammo but also the brass cased ammo as well. I just purchased 2 boxes of Blazer 357 mag with aluminum casing and even though they're not banned at the...

2 questions. 1) I have a new S&W stainless steel revolver. I've cleaned the front of the cylinder with Hoppes no 9 and a bronze toothbrush style brush and it comes very clean. Will doing this repeatedly harm the surface? 2) I have an aluminum S&W revolver (including the cylinder) with a matt...

2 questions. 1) I have a new stainless steel revolver. I've cleaned the front of the cylinder with Hoppes and a bronze brush and it comes very clean. Will doing this repeatedly harm the surface? 2) I have an aluminum revolver (including the cylinder) with a matt finish that I haven't fired yet...