Search results for query: *

So I just used up the powders that I normally use for 9mm and wanted to get your input - based upon actual experience only please - as to which of the following powders (I have them all already) would provide the lowest recoil at minimum powder loads. Please note, I am not asking for load data...

I recently acquired a SAA (Cimarron-Arms/Uberti Evil Roy) w/a 5 1/2" barrel and am looking for suggestions -based upon your actual experience- on low recoil/cowboy loads using components that I already have. I have extensive reloading experience with other calibers in both handgun & rifle, just...

I’m new to CZ’s and have a recently purchases (new) CZ75B and now have almost 800 rounds through it. At about 500 rounds the trigger pin starting walking out and I replaced it with a CGW floating trigger pin and also changed the trigger return spring to their reduced power version (to make it...

So, I have several powders that can be used for 9 and would like the collective wisdom from those who have used these to offer their opinions. I'm not looking for load data - I'll develop ladders and chrono the results - just input as to which would offer the best combo of low recoil with...

I've run out of some of my powders but have a bunch of AA#5 and Bullseye left. Looking for soft target loads for 9mm using 125gr coated lead bullets (the Blue Bullets). These are to shoot out of full size semi-auto's including a G17, a CZ75 and a 1911. Accuracy only needed out to 25yrds...

I was shooting some 357 handloads (158gr SJSP, AA#5, 1466 fps through a 24" barrel) through my Rossi 92 lever action and had a case separation plus one about to separate. I only noticed because I was shooting silhouette and saw the small part of the case land next to me :eek: After...

Has anyone tried the new Caldwell Precision Chronograph G2 - and if so, what did you think of it?

OK, dumb question, but I have a problem with very fine powders when pouring from an 8lb jug. Seems like no matter what funnel I use there is always some powder that gets everywhere. So, who has a great solution - please don't say use smaller jugs - for transferring powder from an 8lb jug to...

While expensive, the LabRadar Doppler based chronograph has a lot of appeal to me as it would work with all of my firearms and at my range. But...it's been promised for over a year now and and I don't know anyone who has seen or used one. So...if anyone has seen and/or used one, what did...

I've been reloading for a while in a number of calibers - including 38/357. For 38/357 I reload for a revolver and have been using a roll crimp with SJSP bullets. I would like to switch to coated (which I have done for 9 & 45) but am unsure regarding crimp for a revolver load...

Yes, I know another red dot thread. What I'm looking for is some real-world experience using this sight. not looking for "...it looks just like the $30 xxx sight..." or someone I knew had one and...I'd like real feedback from actual users. Primary uses for me will be speed steel mounted on...

Looking for the case feeder plate washers that are Dillon sku #13703. What are the specs for the washer (thickness, ID, OD, material)? Don't have them and would like to source them at a box store if it isn't a very oddball item. Thanks!

Been reloading for a while and just picked up a GP100 (6") and a Rossi 92 Lever (24"). Loaded up some rounds using Montana Gold .38/158gr JHP in 38 special cases, S&B SPP and N-340 powder. Don't have the COAL with me but it was roll crimped into the cannelure. Long story short, since I...