cattleman

I started Cowboy Fast Draw and single actions last year. I purchased a uberti cattleman. After 4 months of practice, the gun would suddenly not stay in full cock. It would drop back to half cock. I did have to move the hammer a bit to get the cylinder to rotate to remove the laser cartridge. So...

All, I just acquired a used Uberti Cattleman in .44 Magnum. The serial number is late 27xxx, all matching w/ AA date stamp 1975 date of manufacture. Left side frame stamp below the cylinder: IVER JOHNSON'S FITCHBURG-MASS-U.S.A. My concern lies with the fact that there is no half-cock notch...

Hello all. Hoping the experts in here can guide me through this issue or let me know if this is a job for a gunsmith. I have a pair of Uberti Cattleman 1873’s or technically Cimmaron Thunderers. I just switched the original hammers with new runnin iron hammers from Taylor. The only hammers...

I just got a uberti cattleman SAA and just took it all apart for cleaning. However, i couldnt get the cylinder bushing out. I was told the gun was made in ‘93 so maybe no one took it out to clean and its just stuck, but i was wondering if uberti ever made their cattleman’s without a removable...

Hi everyone, Wanted to share my experience with the Uberti Cattlemen II (or "new model") revolvers. I picked up a pair this spring for cowboy action shooting in 45 Colt, and their performance hasn't been what I would call reliable. Both suffer from off-center primer strikes that can cause...

new revolver functioned ok little rough took it apart installed wolf spring kit and smoothed some rough edges, put back together and cylinder and hammer lock up unless i dont tighten trigger spring all the way down this happens with stock spring also, if i leave the tension off the trigger...