m&p

I took two 10mm handguns, a Kimber Camp Guard and a S&W M&P10mm, and seven different 10mm factory loads to the range today and compared them on a chronograph. The Blazer actually did better than I expected. The Sig V-crown 180 grain and the Underwood loads did well too.

(All pictures taken safely.) Winchester Defender 147 Grain Bonded JHP.

Smith and Wesson 9mm M2.0 Compact 3.6". 15+1 capacity. 3.6" Barrel. Winchester Defender 147 Grain Bonded JHP.

Little 9mm...

I’ve had my M&P 40 compact 1.0 for ten years. Two years ago I bought an extra slide that I sent away last month to be milled for a red dot and nitrited by DP Custom Works. It came back early so it’s a complete rebuild as I decided it was time to replace the springs as preventive maintenance...

I purchased an M&P M2.0 5" Pro series model 11828 UPC 022188871388 in December, as the intended host for a red-dot. Prior to purchase I had concerns regarding Smith & Wesson's use of plastic optic adapter plates, but was assured they did not carry loads and were therefore a non- issue. The...

For anyone who happens to have experience with both of these guns, which one feels better to shoot, in your opinion (trigger, recoil, grip/ergonomics, etc)? I hear that the M&P has better ergonomics and provides a better grip, and is more naturally pointable than the Glock 26. I also hear that...

Does anyone know where a guy can find a schematic for a Smith & Wesson M&P shield? All that I've been able to find is one for the full-size or the compact.

Hello all, I recently sent my M&P9c in for warranty repair. There was some unexplained damage to the part of my slide that pushes the trigger bar out of the way during cycling. It had a great trigger before I sent it in, but they replaced the slide and now my trigger is extremely gritty...

So, I really like my new 5” M&P 2.0 with the thumb safety. I intentionally bought it WITH the thumb safety because I WANT the extra safety and because I have carried a 1911 for 10+ years and know what to do with it. The problem is that the soft, ambi-safety has been bumped OFF SAFE three times...

Hi all, After a few months of consideration, today I bought my first AR-15 style rifle. It's a used S&W M&P 15 that I found at my local gun shop in great condition for $599 - took it down in the shop and inspected for wear to make sure there wasn't anything drastically wrong with it. I figure...

I started typing this up in the thread I found about the Gen 5 Glocks, but I figure I probably shouldn't clog up that thread with this. I attended a Glock day that a local gun store put on a couple weeks ago and got to try out the new gen 5 glocks, both the 19 and the 17. I think they've more...

Was shooting a little bit today using a target from Pistol Training. You start at 3 yds and back out to further ranges. This target is 5 yds. Not great but not real bad. I have seen others do much better. I shot my S&W SD 9VE with cheap Magtech 115gr bullets. The M&P 40 ammo was Freedom...

Hey all, I'm wondering if any of you have experience with full size mags in the 9mm compact (with out an adapter) and have you had any failures?