Zanealexander1
Member
- Joined
- Sep 27, 2018
- Messages
- 12
I thought about suggesting that and going with some QD (Quick Disconnect) 1.250 loops but didn't mention it. If the QD loops will snap on the existing swivels that is what I would do. Somewhere I have a box of sling hardware and I was going to check but I can't remember where that box is.Ok, thanks. Would leaving the factor studs in and just cutting the loop out be a better decision? I just don’t want to booger anything up.
While I am not sure why you did any drilling if the old stud is out and a new stud & swivel in that's all there should be to it. If the drilling is slightly off centerline I doubt it will matter.So I drilled the rear stud out a little “out of round”. Does anyone see that as an issue that calls for a new stud or should I be fine?