joker1969
Member
I was having a problem trimming my 5.56mm cases using the 3-in-1 trimmer. The trimmer was cutting the cases on an angle. ie: set to trim 5.56mm to 1.750 and one end would be 1.750 and the opposite end would be 1.747 or 1.746. This all started from day one so I called forester up expecting a runaround but the tech said to send the unit back and supply 3 timmed cases and 3 untrimmed cases. So I boxed everything up and sent it out and just about 2 weeks later I received my trimmer and newly trimmed cases that were spot on. The tech wrote me and said that they readjusted the 3-in-1 to factory specs and that I shouldn't have any more problems.Well I just trimmed 300 LC 5.56mm brass set at 1.750 and It works fantastically. The trim is clean as is the chamfer and outside bevel. And best of all, there was no charge. GREAT CUSTOMER SERVICE!!! Thank you Forester.