357 "armscor" brass question

[THe Dove]

Does anybody have personal experience with reloading these? I have just come into about 100 of them and am having a hard time de-priming them. It seams I'm gonna have to extend/lenghthen the de-capping pin on my die???? I haven't had any issues with other brands of brass.

The Dove

 

[rcmodel]

No experiance.

But if the depriming pin isn't extending clear out of the primer pocket at full ram travel?
It needs adjusting anyway.

rc

 

[ReloaderFred]

I load them and don't have any problem. Like rc says, check and make sure your decapping pin extends far enough. Also make sure there isn't a burr or flat spot on the tip of the decapping pin that would be drawing the primer back up into the primer pocket with you withdraw the case from the die. Some anvils will also pinch onto the decapping pin, due to their shape, and polishing the tip of the pin will cure most of those problems.

Hope this helps.

Fred