Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
You are using the old High Contrast theme. We have installed a new dark theme for you, called UI.X. This will work better with the new upgrade of our software. You can select it at the bottom of any page.
"well, when you pull the trigger twice, having only aligned the sights and target once, it happens."
smartalek
Double tapping is a handy way of making sure your target is....dead.
Double feeding however, is the result of the magazine separating slightly on the back weld, causing the bolt to push two rounds into the chamber. This can be fixed by *not* banging your mags on anything hard to "seat" the rounds. If you feel rounds need to be seated, smack the mag against the palm of your hand.
It's called doubling.
It can also be caused by a slam-fire if you are using commercial .223 ammo with soft primers.
Or reloads with crushed primer cups.
The floating firing pin will always dimple the primer of the round as it loads into the chamber.
GI primers are harder and will not go of from that light dimpling.
Softer commercial .223 primers, or damaged ones may, and if so, you get two shots real fast with one trigger pull.
Doubling usually indicates a problem in your fire control group. A common cause is also wear at the nose of the trigger where is catches the hammer or wear on the hammer at the opposite spot.
Typically you see that kind of wear if the trigger is really old or someone tried to polish the trigger to get a better trigger pull and polished right through the very thin case hardening on the trigger.
It is an unsafe condition though and you need to get it fixed as soon as possible.
Before I retired from Uncle Sam 18 months ago, we had this occasionally happen with rebuild M16A2s that were all parts guns. Usually it was because the hammer-spring needed changing, OR occasionally (about 3 times a year) it was because the legs on the springs had not been properly installed on top of the lower receiver pins. As you know, the spring pressure from the legs of the internal spings is what holds the receiver thru-pins in place. Every now and then somebody would assemble a rifle with only one leg on the top of the pin or neither leg. This either made the spring sit canted, which caused problems, or it let the pin walk sideways after a few rounds. So the hammer (usually) would cant at an angle because the pin walked out on one side. When that happens (most of the time) it goes double or full auto a few times before finally jamming up. We had one guy who thought it was supposed to do that actually make expert on his rifle qual with a rifle that autoed every round in the mag.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.