MonkTx
Member
- Joined
- Oct 24, 2005
- Messages
- 114
Hello all,
I recently purchased an sp101 in 327mag and have some questions about loading for it. I have a lot of 32 h&r and 32 s&w long cases and I plan to order a few thousand wadcutter bullets.
I have switched over to coated bullets for all my autoloaders and taper crimp them but was wondering if I should stick to lubed lead for revolvers.
It is my understanding that revolver loads respond better to a firm roll crimp with better ignition. Do I have that right?
Or, have any of you found the coating can handle a good roll crimp without being scraped off?
Thanks,
Monte
I recently purchased an sp101 in 327mag and have some questions about loading for it. I have a lot of 32 h&r and 32 s&w long cases and I plan to order a few thousand wadcutter bullets.
I have switched over to coated bullets for all my autoloaders and taper crimp them but was wondering if I should stick to lubed lead for revolvers.
It is my understanding that revolver loads respond better to a firm roll crimp with better ignition. Do I have that right?
Or, have any of you found the coating can handle a good roll crimp without being scraped off?
Thanks,
Monte