Saluki91
Member
I have a MEC Sizemaster .410 press that came out of the box set up for 3" hulls.
Every hull I own is 2.5", so I got the short kit to convert the press.
The conversion went smoothly until I noticed that the resizing/depriming station is a hot mess. The decapping rod doesn't even get close to reaching the bottom of the hull, and the hull appears to sink all the way to the bottom of the resizing collet. A photo is attached.
I tried calling MEC this afternoon, but they were closed. My hope is that someone here might be able to steer me in the right direction.
Thanks!
Every hull I own is 2.5", so I got the short kit to convert the press.
The conversion went smoothly until I noticed that the resizing/depriming station is a hot mess. The decapping rod doesn't even get close to reaching the bottom of the hull, and the hull appears to sink all the way to the bottom of the resizing collet. A photo is attached.
I tried calling MEC this afternoon, but they were closed. My hope is that someone here might be able to steer me in the right direction.
Thanks!
