gifbohane
Member
- Joined
- Nov 7, 2016
- Messages
- 1,181
Picture 2 is a chambered Remington factory round in my Stock CZ barrel. OAL is 1.080.
Picture 1 and 3 is a foto of my Blazer and Win reloads to 1.100.
All plonk to this same depth . It is considerable higher than my 9mm S & W barrel that seat flush to the top of the barrel. But I cannot believe that all three are seating too high. I was having some trouble with FTF on my stuff at 1.135. Here a painted dummy round twists (not easily) in the chamber but with some of the marker taken off just beyond the top of the case
Does this look right?
Picture 1 and 3 is a foto of my Blazer and Win reloads to 1.100.
All plonk to this same depth . It is considerable higher than my 9mm S & W barrel that seat flush to the top of the barrel. But I cannot believe that all three are seating too high. I was having some trouble with FTF on my stuff at 1.135. Here a painted dummy round twists (not easily) in the chamber but with some of the marker taken off just beyond the top of the case
Does this look right?