Encoreman
Member
Hi all I have an older much used square deal. I loaded over 1K .38 special with little primer problems. Then I switched to .40S&W and loaded 20 or so and the issue started. It will prime a case or a few then not put one out to prime then they start falling to the floor. I have loaded several thousand on this press and this has got me buffaloed. I replaced the blue tip on primer drop tube after emptying it and cleaning it, took out the plunger that had the flat spring steel behind it. It will work good for 15-20 then hang up and I have to remove primer system. I will call Dillon tomorrow, but if anyone has a fix, let me know. I am thinking of sending it back for an overhaul. Thanks for your comments, Mac