After much frustration with hard to adjust sights and bullet impacts 3" apart @ 50 yards between SV ammo and HV ammo, I plan on D&T my 10/22 for the Williams FP receiver sight.
I had a similar sight years ago on a Rossi 1892 357 and it was a lot of fun being able to adjust with repeatable accuracy for different loads.
Anyway, IIRC, it's a #6-48, but now I can't seem to find that reference anywhere.
Was planning on getting a Hanson carbon #6-48 taper tap because it looks like it will be a through hole, a #31 drill bit and some Tap Magic cutting oil.
I did D&T an Encore barrel once for open sights, but I had a machine shop at my disposal then. I'm looking for a small drill press to drill the hole and guide the tap.
Any advice from the pros?
I had a similar sight years ago on a Rossi 1892 357 and it was a lot of fun being able to adjust with repeatable accuracy for different loads.
Anyway, IIRC, it's a #6-48, but now I can't seem to find that reference anywhere.
Was planning on getting a Hanson carbon #6-48 taper tap because it looks like it will be a through hole, a #31 drill bit and some Tap Magic cutting oil.
I did D&T an Encore barrel once for open sights, but I had a machine shop at my disposal then. I'm looking for a small drill press to drill the hole and guide the tap.
Any advice from the pros?