wiiawiwb
Member
- Joined
- Jun 30, 2010
- Messages
- 302
I just finished seating and roll crimping my first 45LC. It will be used in a Ruger SRH 454 Casull. I am using a coated Missouri Bullet 255 gr. SWC. and once-fired
http://missouribullet.com/details.php?prodId=210&category=20&secondary=14&keywords=
I am a little concerned because the OAL is 1.602 which is longer than 1.600 per the Lyman book. The trouble was that if I seated the bullet any deeper it would be above the crimp groove. Is being over the OAL an issue?
I've included two pictures so you can see it and get your feedback on my seating and roll crimp too.
http://missouribullet.com/details.php?prodId=210&category=20&secondary=14&keywords=
I am a little concerned because the OAL is 1.602 which is longer than 1.600 per the Lyman book. The trouble was that if I seated the bullet any deeper it would be above the crimp groove. Is being over the OAL an issue?
I've included two pictures so you can see it and get your feedback on my seating and roll crimp too.