hackworth99
Member
Maybe I'm just being paranoid, but if I cycle the slide on my glock a certain way, the fring pin will protrude from the breech face. Slowly cycling the slide forward, the safety engages and pushes it back? Is this normal?
If a loaded magazine was instered with the firing pin protruding, and the slide racked, would it not fire out of battery reagrdless of the safety?
I also noticed on the firing pin, after wiping some grease off, it looks like it is chipped on the side, but the function check goes through fine without problems.
If a loaded magazine was instered with the firing pin protruding, and the slide racked, would it not fire out of battery reagrdless of the safety?
I also noticed on the firing pin, after wiping some grease off, it looks like it is chipped on the side, but the function check goes through fine without problems.