How would you go about marking the center of a Glock factory/plastic front sight? This is what is known as a "gip" and is to increase accuracy by providing a smaller aiming point.
I could do it with a knife blade in a measured center but was hoping for a somewhat less permanent method first, followed by a more permanent method.
Again, the goal is to mark a small spot at the center and top of the front sight to focus on when shooting longer range.
I could do it with a knife blade in a measured center but was hoping for a somewhat less permanent method first, followed by a more permanent method.
Again, the goal is to mark a small spot at the center and top of the front sight to focus on when shooting longer range.