Ok, I have my lee classic turret press functioning pretty well all around, however the primer cups on both the small and the large primer lever arms get stuck on the shellholder when you try to lower the ram all the way down. This stops the whole press right there, keeping it from going all the way down and basically rendering the entire priming system useless.
It's almost like the top of the base on the press is too low, which doesn't allow the primer lever arm to swing all the way into the ram before the shellholder gets too low.
Anybody else run into this problem? Thanks for the help!
It's almost like the top of the base on the press is too low, which doesn't allow the primer lever arm to swing all the way into the ram before the shellholder gets too low.
Anybody else run into this problem? Thanks for the help!