Havicman
Member
I'm in the proccess of working up a load and noticed the primer srikes seem to be a little off. I don't believe this will be a problem but wanted to get some input. For me it looks like the firing pin is longer than what I'm used to and causing a deep impact. This is for a Winchester High Wall and I would like to keep the pressures down. The load is for a 25 Krag based on the 30 Army/30-40 Krag brass so I don't have any "formal" load data. I do have some notes that have some load data that I am using. The primer strikes didn't seem to change very much between the lower charges and the higher charges.